HI,
I am trying to figure out a way by which I can send following trap command
without adding/mentioning the port number. The receiver is receiving the
trap when the custom port number is mentioned
snmptrap -v 2c -c rscommunity <DEST-IP-ADDRESS>:166 ""
TRAP-TEST-MIB::demotraps SNMPv2-MIB::sysLocation.0 s "some message"
By default, the following command does not require the port number to be
mentioned when the snmptrapd is using the default port-161.
snmptrap -v 2c -c rscommunity <DEST-IP-ADDRESS> ""
TRAP-TEST-MIB::demotraps SNMPv2-MIB::sysLocation.0 s "some message"
Additional info:
firewall opened for the above mentioned custom port
SELINUX
/etc/sysconfig/selinux has the following edit "SELINUX=disabled"
(essentially SELINUX is off)
So far, I have been following the
http://www.net-snmp.org/tutorial/tutorial-5/commands/snmptrap.html to
understand/test
Test Bed
2xservers with NET-SNMP version: 5.7.2 on CentOS 7.2
Thanks in advance
-Hemanth
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports.http://sdm.link/zohodev2dev
_______________________________________________
Net-snmp-users mailing list
Net-snmp-users@lists.sourceforge.net
Please see the following page to unsubscribe or change other options:
https://lists.sourceforge.net/lists/listinfo/net-snmp-users
