On Thu, 18 Nov 1999, Daniel E. Lautenschleger wrote:
> I have several Linux boxes running Netatalk. Bear with me as I'm not that
> familiar with the AppleTalk protocol.
>
> I see how one can go into the AppleTalk control panel and view the
> AppleTalk address for a particular machine. My question is how do you
> determine the AppleTalk address that a router is assigning to a Linux box.
> I'm assuming the address is assigned by the router. Sorry if I'm wrong.
It is assigned by the route if you don't put -seed in the atalk.conf file.
run ifconfig, and it shows you your address:
eth0 Link encap:Ethernet HWaddr 00:10:4B:6A:4F:F5
inet addr:192.168.10.1 Bcast:192.168.10.255 Mask:255.255.255.0
-- >> EtherTalk Phase 2 addr:10/10
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3308 errors:1 dropped:0 overruns:0 frame:1
TX packets:8686 errors:0 dropped:0 overruns:0 carrier:181
collisions:0
> Also, is there a software program that allows you to resolve AppleTalk
> addresses to hardware addresses on a network?
not sure about this. should be something about though.
> Thanks, folks.
>
> Dan
>
> Daniel E. Lautenschleger, MCP
> Network Administrator & Computer Support
> Robert M. Bock Laboratories
> [EMAIL PROTECTED]
> voice: 608-262-3403
> fax: 608-262-4570
>
-- Ben
/----------------------------------------------+------------------------\
| Benjamin Lee | |
| Internet Administrator | Mobile: 0416 122 779 |
| PowerNET Computer Consultants P/L | Fax: +613 9425 9091 |
| 50 Madden Grove, Burnley 3121 VIC Australia | Phone: +613 9425 9090 |
\----------------------------------------------+------------------------/
"Well," Brahma said, "even after ten thousand explanations, a fool is no
wiser, but an intelligent man requires only two thousand five hundred."
-- The Mahabharata.
