On 06/25/15 12:30, Christos Zoulas wrote:
In article <[email protected]>,
William A. Mahaffey III <[email protected]> wrote:
Everything looked OK w/ df & install proceeded & finished OK. Whassup
here ? TIA for any pointers & have a good one.
Are you sure your root is ffsv2 and not ffsv1? Why is the a partition
offset 2048?
christos
Not sure about either. Disklabel thinks the slice is RAID under the
RAID[0,1], & 4.2BSD on top off the RAID 'device'. I am definitely *not*
expert at the ins & outs of NetBSD disk setup, booting, etc. I mostly
followed the (previously attached) README file to set everything up, &
that's what was recommended there (*not* an ideal circumstance, I know,
but the best I could do). I thought ffsv2 had superceded v1 a while
back, but I could be mistaken. I also thought 4.2BSD was synonomous w/
FFSv2, no ? What should the root filesystem be for the boot process to
work correctly ? Also, what should the offset of the root partition be ?
I took defaults when I fdisk'ed the drive (fdisk -iau0 wd[0,1]), as
instructed in the afore-mentioned README file. Thanks for your reply &
TIA for any new guidance & have a good one.
--
William A. Mahaffey III
----------------------------------------------------------------------
"The M1 Garand is without doubt the finest implement of war
ever devised by man."
-- Gen. George S. Patton Jr.
