On Wed, Mar 02, 2016 at 08:35:42AM +0330, Mohammad Badie Zadegan wrote: BTW, I'm also using OpenBSD, as my second OS on "main" computer....)) It is good system, of course.... but there is no framebuffer at all in openbsd((( > Hi Mike, > First of all I tried with default config of last release but it did not > worked! > At now I switched to OpenBSD with no issue and run X with vesa good. > Thanks for your Help too. > Regards. > > Sent from my iPhone > > > On Mar 2, 2016, at 3:02 AM, Mike <gin...@email.su> wrote: > > > >> On Fri, Feb 26, 2016 at 05:54:49PM +0330, Mohammad Badie Zadegan wrote: > >> I set vesa 0x118 mode in boot prompt and I saw the boot process was change > >> visiblity to new mode but still errored me (EE) No Device detected. > >> BTW, I didn't use current version. > >> Is that I must use current version for vesa? > >> > >>>> On Feb 26, 2016, at 3:23 PM, Roy Bixler <rcbix...@nyx.net> wrote: > >>>> > >>>> On Fri, Feb 26, 2016 at 06:56:17AM +0330, Mohammad BadieZadegan wrote: > >>>> Yes, the main reason is that nVidia did not handle its source code. > >>>> How i can try booting from vesa framebuffer? > >>>> Which NetBSD image produce with vesa framebuffer defaultly? > >>>> Thanks for your attention. > >>> > >>> From the boot prompt. Try a "man boot" to see the commands. One of the > >>> commands is "vesa" and you can do "vesa list" to see which modes are > >>> available. > >>> > >>> -- > >>> Roy Bixler <rcbix...@nyx.net> > >>> "The fundamental principle of science, the definition almost, is this: the > >>> sole test of the validity of any idea is experiment." > >>> -- Richard P. Feynman > > Hi Mohammad... I guess you don't need current... First of all - did you > > try to start X without config at all?? Most probably you just have to > > specify the right BUSID in xorg.conf.... I'm using similar configuration > > - framebuffer mode+nvidia cards+Xorg... It works with both nv and > > vesa(I'm not sure about vesa... I do not remember exactly) and wsfb > > drivers! But when using your own xorg.conf you should specify slightly > > different BusID's with different drivers...) Can you send your > > Xorg.0.log, then running X --configure/ startx with config( pls also attach > > your video device section of config)/ startx w/out config / Xorg > > -logverbose 4 /)?? > > I've had 1680x1050 resolution in both console and X(using nv driver - > > it's better... but before I've had to use wsfb, because I couldn't > > understand for a long time, how to make this works "right"... finnaly > > i've found running X with wsfb driver had too many flaws...and figured > > out about this part of configuration...) > > So I think I can help you, if you will still have problems, after the > > above actions...) > >
-- Cool signature, or maybe script, fortune, etc...
