My guess is that you're going to have to get a video of the screen
during installation.
On Mon, 7 May 2018, Kathe wrote:
From [email protected] Mon May 7 15:50:58
2018
From: Martin Husemann <[email protected]>
To: Kathe <[email protected]>
Cc: [email protected]
Subject: Re: 8.0 rc1 barfs during install
Sender: [email protected]
On Mon, May 07, 2018 at 03:46:33PM +0000, Kathe wrote:
i have an amd64 system which runs well with freebsd, openbsd and ubuntu.
with netbsd 8.0 rc1, it barfs while outputing the message below;
sdhc0: adma error, status ff
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
Could you provide any details?
Does it hang at that point, just wait for a bit and then continue to boot?
If possible send the full output of the dmesg command, please.
Martin
my system works well with freebsd, openbsd, ubuntu.
under netbsd 8.0 rc1, the following message keeps getting printed;
sdhc0: adma error, status ff
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdmmc0: sdmmc_mem_enable failed with error 60
sdmmc0: couldn't enable card: 60
i can't get to the point of plucking out the dmesg, the message
above keeps getting repeated till the point i power-down the
system.
--
Hisashi T Fujinaka - [email protected]
BSEE + BSChem + BAEnglish + MSCS + $2.50 = coffee
