From:                   "MAURICE L. DRAKE" <[EMAIL PROTECTED]>

> Would someone please tell me how to unsubscribe from this
> list. Thanks.

    First, ask your Internet Provider to mail you an Unsubscribing Kit. 
    Then follow these directions. 
    The kit will most likely be the standard no-fault type. Depending on 
    requirements, System A and/or System B can be used. When 
    operating System A, depress lever and a plastic dalkron 
    unsubscriber will be dispensed through the slot immediately 
    underneath. When you have fastened the adhesive lip, attach 
    connection marked by the large `X' outlet hose. Twist the silver- 
    coloured ring one inch below the connection point until you feel it 
    lock. 
    The kit is now ready for use. The Cin-Eliminator is activated by the 
    small switch on the lip. When securing, twist the ring back to its 
    initial condition, so that the two orange lines meet. Disconnect. Place 
    the dalkron unsubscriber in the vacuum receptacle to the rear. 
    Activate by pressing the blue button. 
    The controls for System B are located on the opposite side. The red 
    release switch places the Cin-Eliminator into position; it can be 
    adjusted manually up or down by pressing the blue manual release 
    button. The opening is self- adjusting. To secure after use, press the 
    green button, which simultaneously activates the evaporator and 
    returns the Cin-Eliminator to its storage position. 
    You may log off if the green exit light is on over the evaporator . If 
    the red light is illuminated, one of the Cin-Eliminator requirements 
    has not been properly implemented. Press the ``List Guy'' call button 
    on the right of the evaporator . He will secure all facilities from his 
    control panel. 
    To use the Auto-Unsub, first undress and place all your clothes in 
    the clothes rack. Put on the velcro slippers located in the cabinet 
    immediately below. Enter the shower, taking the entire kit with you. 
    On the control panel to your upper right upon entering you will see a 
    ``Shower seal'' button. Press to activate. A green light will then be 
    illuminated immediately below. On the intensity knob, select the 
    desired setting. Now depress the Auto-Unsub activation lever. 
    Bathe normally. 
    The Auto-Unsub will automatically go off after three minutes unless 
    you activate the ``Manual off'' override switch by flipping it up. 
    When you are ready to leave, press the blue ``Shower seal'' release 
    button. The door will open and you may leave. Please remove the 
    velcro slippers and place them in their container. 
    If you prefer the ultrasonic log-off mode, press the indicated blue 
    button. When the twin panels open, pull forward by rings A & B. 
    The knob to the left, just below the blue light, has three settings, low, 
    medium or high. For normal use, the medium setting is suggested. 
    After these settings have been made, you can activate the device by 
    switching to the ``ON'' position the clearly marked red switch. If 
    during the unsubscribing operation, you wish to change the settings, 
    place the ``manual off'' override switch in the ``OFF'' position. You 
    may now make the change and repeat the cycle. When the green 
    exit light goes on, you may log off and have lunch. Please close the 
    door behind you. 



--
Oliver Wagner <[EMAIL PROTECTED]>  http://www.vapor.com/
Finger: [EMAIL PROTECTED]          ICQ: you're kidding :)
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>

Reply via email to