[patch 4/6] s390: qeth :allow setting of attribute "route6" to "no_router".
From: Ursula Braun <[EMAIL PROTECTED]> when setting route6 attribute back to no_router qeth does not issue an IP ASSIST command to reset router value to no_router. Once primary_router is set device stays in this mode. Issue an IP ASSIST command when no_router is set in route6. Device will be reset and thus will not longer run as a primary router. Signed-off-by: Frank Pavlic <[EMAIL PROTECTED]> diffstat: qeth_main.c | 5 ----- 1 files changed, 5 deletions(-) diff --git a/drivers/s390/net/qeth_main.c b/drivers/s390/net/qeth_main.c index 69329ea..021cd5d 100644 --- a/drivers/s390/net/qeth_main.c +++ b/drivers/s390/net/qeth_main.c @@ -7339,11 +7339,6 @@ qeth_setrouting_v6(struct qeth_card *car qeth_correct_routing_type(card, &card->options.route6.type, QETH_PROT_IPV6); - if ((card->options.route6.type == NO_ROUTER) || - ((card->info.type == QETH_CARD_TYPE_OSAE) && - (card->options.route6.type == MULTICAST_ROUTER) && - !qeth_is_supported6(card,IPA_OSA_MC_ROUTER))) - return 0; rc = qeth_send_setrouting(card, card->options.route6.type, QETH_PROT_IPV6); if (rc) { - To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html