Hello.
I have a need to de-assert the active-low PHY hardware reset signal
(mapped to a GPIO) before the MDIO bus scansince it's left asserted by the
bootloader (U-Boot). I have a device tree probed MAX driver (ravb) and I'm
somewhat at a loss about where and how to do this. The existing example
(Freescale FEC) has DT props controlling the PHY reset GPIO in the MAC device
node but it doesn't seem correct at all since this signal has nothing to do
with the MAC, only with PHY! I therefore would like this "phy-reset-gpios"
property to be defined under the PHY node but this way I'll have to add the
handling of this prop to the phylib (it would be too late if I did that in a a
PHY driver method since that). I'm also seeing the mii_bus::reset() method and
it seems a good place but I'm not sure if my PHY's reset signal can be treated
as the reset signal for the whole bus; if it would, the DT prop should be
placed under the MAC node anyway...
Florian (and everybody), what's your thoughts on this matter?
MBR, Sergei
