From: Niklas Cassel <[email protected]> phy_device->supported is originally set by the PHY driver. The ethernet driver should filter phy_device->supported to only contain flags supported by the IP. The IP supports setting rx and tx flow control independently, therefore SUPPORTED_Pause and SUPPORTED_Asym_Pause should not be cleared. If the flags are cleared, pause frames cannot be enabled (even if they are supported by the PHY).
Signed-off-by: Niklas Cassel <[email protected]> Signed-off-by: Jesper Nilsson <[email protected]> Acked-by: Lars Persson <[email protected]> --- drivers/net/ethernet/synopsys/dwc_eth_qos.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/synopsys/dwc_eth_qos.c b/drivers/net/ethernet/synopsys/dwc_eth_qos.c index 0d0053128542..d775729648ef 100644 --- a/drivers/net/ethernet/synopsys/dwc_eth_qos.c +++ b/drivers/net/ethernet/synopsys/dwc_eth_qos.c @@ -982,7 +982,8 @@ static int dwceqos_mii_probe(struct net_device *ndev) if (netif_msg_probe(lp)) phy_attached_info(phydev); - phydev->supported &= PHY_GBIT_FEATURES; + phydev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause | + SUPPORTED_Asym_Pause; lp->link = 0; lp->speed = 0; -- 2.1.4
