From: Emil Tantilov <emil.s.tanti...@intel.com>
Remove the logic which would previously skip the link configuration
in the case where we are already at the requested speed in
ixgbe_setup_mac_link_multispeed_fiber().
By exiting early we are skipping the link configuration and as such
the driver may not always configure the PHY correctly for SFP+.
Signed-off-by: Emil Tantilov <emil.s.tanti...@intel.com>
Tested-by: Andrew Bowers <andrewx.bow...@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirs...@intel.com>
---
drivers/net/ethernet/intel/ixgbe/ixgbe_common.c | 18 ------------------
1 file changed, 18 deletions(-)
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
index 76ad0e0bd542..7af85f505bad 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
@@ -4121,15 +4121,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct
ixgbe_hw *hw,
speedcnt++;
highest_link_speed = IXGBE_LINK_SPEED_10GB_FULL;
- /* If we already have link at this speed, just jump out */
- status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
- false);
- if (status)
- return status;
-
- if (link_speed == IXGBE_LINK_SPEED_10GB_FULL && link_up)
- goto out;
-
/* Set the module link speed */
switch (hw->phy.media_type) {
case ixgbe_media_type_fiber:
@@ -4181,15 +4172,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct
ixgbe_hw *hw,
if (highest_link_speed == IXGBE_LINK_SPEED_UNKNOWN)
highest_link_speed = IXGBE_LINK_SPEED_1GB_FULL;
- /* If we already have link at this speed, just jump out */
- status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
- false);
- if (status)
- return status;
-
- if (link_speed == IXGBE_LINK_SPEED_1GB_FULL && link_up)
- goto out;
-
/* Set the module link speed */
switch (hw->phy.media_type) {
case ixgbe_media_type_fiber:
--
2.12.2
