Rahul Lakkireddy <rahul.lakkire...@chelsio.com> writes: > On production servers running variety of workloads over time, kernel > panic can happen sporadically after days or even months. It is > important to collect as much debug logs as possible to root cause > and fix the problem, that may not be easy to reproduce. Snapshot of > underlying hardware/firmware state (like register dump, firmware > logs, adapter memory, etc.), at the time of kernel panic will be very > helpful while debugging the culprit device driver. > > This series of patches add new generic framework that enable device > drivers to collect device specific snapshot of the hardware/firmware > state of the underlying device at the time of kernel panic. The > collected logs are appended to vmcore along with details, such as > start address and length of the logs, which are required for > extraction during post-analysis. > > Device drivers can use crash_driver_dump_register() to register their > callback that collects underlying device specific hardware/firmware > logs during kernel panic (i.e. before booting into the second kernel). > Drivers can unregister with crash_driver_dump_unregister(). > > To extract the device specific hardware/firmware logs using crash: > > crash> help -D | grep DRIVERDUMP > DRIVERDUMP=(cxgb4_0000:02:00.4, ffffb131090bd000, 37782968) > > crash> rd ffffb131090bd000 37782968 -r hardware.log > 37782968 bytes copied from 0xffffb131090bd000 to hardware.log > > Patch 1 adds API to allow drivers to register callback to > collect the device specific hardware/firmware logs. > > Patch 2 shows a cxgb4 driver example using the API to collect > hardware/firmware logs during kernel panic. > > Suggestions and feedback will be much appreciated.
I strongly suggest you figure out how to run this code in the crash recovery kernel before your hardware is initialized. That will give you a known good kernel to perform your collection from. Every line of code we add to the kexec on panic code path tends to add to it's fragility and increase the chance you won't get any information at all. When the assumption is it is something wrong with your driver/hardware that caused the crash, calling into your driver is a very bad idea. Especially running code that does callbacks and all kinds of other cute things. Doing this as the crash recover kernel boots up before much if any hardware is initialized seems like a fine thing to do, and just needs a little coordination with userspace to ensure the information gets saved when a vmcore is computed. Eric