On Thu, Sep 13, 2018 at 11:18:16AM +0300, Eran Ben Elisha wrote:
> Add devlink-health man page. Devlink-health tool will control device
> health attributes, sensors, actions and logging.
>
> Signed-off-by: Eran Ben Elisha <era...@mellanox.com>
>
> -------------------------------------------------------
> Copy paste man output to here for easier review process of the RFC.
>
> DEVLINK-HEALTH(8)
> Linux
> DEVLINK-HEALTH(8)
>
> NAME
> devlink-health - devlink health configuration
>
> SYNOPSIS
> devlink [ OPTIONS ] health { COMMAND | help }
>
> OPTIONS := { -V[ersion] | -n[no-nice-names] }
>
> devlink health show [ DEV ] [ sensor NAME ]
>
> devlink health sensor set DEV name NAME [ action NAME { active |
> inactive } ]"
>
> devlink health action set DEV name NAME period PERIOD count COUNT fail
> { ignore | down }
>
> devlink health action reinit DEV name NAME
>
> devlink health help
>
> DESCRIPTION
> devlink-health tool allows user to configure the way driver treats
> unexpected status. The tool allows configuration of the sensors that can
> trigger health activity. Set for each sensor the follow up operations, such
> as,
> reset and dump of info. In addition, set the health activity
> termination action.
>
> devlink health show - Display devlink health sensors and actions attributes
> DEV - Specifies the devlink device to show. If this argument is
> omitted, all devices are listed.
>
> Format is:
> BUS_NAME/BUS_ADDRESS
>
> sensor NAME - Specifies the devlink sensor to show.
>
Perhaps the commands should include the optional arguments so when
reading the description one doesn't have to scroll to the top of the
page all the time
e.g
devlink health show [ DEV ] [ sensor NAME ] - Display devlink health
sensors and actions attributes
> devlink health sensor set - sets devlink health sensor attributes
> DEV Specifies the devlink device to show.
set
> name NAME
> Name of the sensor to set.
>
> action NAME { active | inactive }
> Specify which actions to activate and which to deactivate
> once a sensor was triggered. actions can be dump, reset, etc.
>
> devlink health action set - sets devlink action attributes
> DEV Specifies the devlink device to set.
>
> name NAME
> Specifies the devlink action to set.
This is a little unclear to me?
> period PERIOD
> The period on which we limit the amount of performed actions,
> measured in seconds.
>
> count COUNT
> The maximum amount of actions performed in a limit time frame.
Perhaps
The maximum number of actions performed in a limited time frame.
> fail { ignore | down }
> Specify the behavior once count limit was reached.
>
> ignore - Ignore errors without execution of any action.
>
> down - Driver will remain in nonoperational state.
>
> devlink health action reinit - reset devlink action attributes (period,
> count, fail, etc)
> DEV Specifies the devlink device to set.
>
> name NAME
> Specifies the devlink action to set.
Perhaps s/set/reinitialise/g for the above two descriptions.
Hope this helps,
Tobin.
