The Topaz family should have different phylink_validate method from the Peridot, since on Topaz the port supporting 2500BaseX mode is port 5, not 9 and 10.
Signed-off-by: Marek Behún <[email protected]> --- drivers/net/dsa/mv88e6xxx/chip.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) diff --git a/drivers/net/dsa/mv88e6xxx/chip.c b/drivers/net/dsa/mv88e6xxx/chip.c index 8dca2c949e73..2b285b0b9e06 100644 --- a/drivers/net/dsa/mv88e6xxx/chip.c +++ b/drivers/net/dsa/mv88e6xxx/chip.c @@ -632,6 +632,20 @@ static void mv88e6185_phylink_validate(struct mv88e6xxx_chip *chip, int port, mv88e6065_phylink_validate(chip, port, mask, state); } +static void mv88e6341_phylink_validate(struct mv88e6xxx_chip *chip, int port, + unsigned long *mask, + struct phylink_link_state *state) +{ + if (port >= 5) + phylink_set(mask, 2500baseX_Full); + + /* No ethtool bits for 200Mbps */ + phylink_set(mask, 1000baseT_Full); + phylink_set(mask, 1000baseX_Full); + + mv88e6065_phylink_validate(chip, port, mask, state); +} + static void mv88e6352_phylink_validate(struct mv88e6xxx_chip *chip, int port, unsigned long *mask, struct phylink_link_state *state) @@ -3052,7 +3066,7 @@ static const struct mv88e6xxx_ops mv88e6141_ops = { .vtu_loadpurge = mv88e6352_g1_vtu_loadpurge, .serdes_power = mv88e6341_serdes_power, .gpio_ops = &mv88e6352_gpio_ops, - .phylink_validate = mv88e6390_phylink_validate, + .phylink_validate = mv88e6341_phylink_validate, }; static const struct mv88e6xxx_ops mv88e6161_ops = { @@ -3684,7 +3698,7 @@ static const struct mv88e6xxx_ops mv88e6341_ops = { .gpio_ops = &mv88e6352_gpio_ops, .avb_ops = &mv88e6390_avb_ops, .ptp_ops = &mv88e6352_ptp_ops, - .phylink_validate = mv88e6390_phylink_validate, + .phylink_validate = mv88e6341_phylink_validate, }; static const struct mv88e6xxx_ops mv88e6350_ops = { -- 2.19.2
