This hook only implements a minimal set of ioctl hooks to be able to access MII regs by using phytool. When using this simple MAC controller, it's pretty difficult to do debugging of the PHY chip without checking MII regs.
Signed-off-by: Alexandru Ardelean <[email protected]> Reviewed-by: Radhey Shyam Pandey <[email protected]> --- drivers/net/ethernet/xilinx/xilinx_emaclite.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c index b03a417d0073..0aea05ac6dcc 100644 --- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c +++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c @@ -1229,12 +1229,29 @@ xemaclite_poll_controller(struct net_device *ndev) } #endif +/* Ioctl MII Interface */ +static int xemaclite_ioctl(struct net_device *dev, struct ifreq *rq, int cmd) +{ + if (!dev->phydev || !netif_running(dev)) + return -EINVAL; + + switch (cmd) { + case SIOCGMIIPHY: + case SIOCGMIIREG: + case SIOCSMIIREG: + return phy_mii_ioctl(dev->phydev, rq, cmd); + default: + return -EOPNOTSUPP; + } +} + static const struct net_device_ops xemaclite_netdev_ops = { .ndo_open = xemaclite_open, .ndo_stop = xemaclite_close, .ndo_start_xmit = xemaclite_send, .ndo_set_mac_address = xemaclite_set_mac_address, .ndo_tx_timeout = xemaclite_tx_timeout, + .ndo_do_ioctl = xemaclite_ioctl, #ifdef CONFIG_NET_POLL_CONTROLLER .ndo_poll_controller = xemaclite_poll_controller, #endif -- 2.17.1
