Hi, Just got a brand new Dell Vostro and it appears to have an unsupported Intel network card:
00:19.0 Ethernet controller: Intel Corporation 82562V-2 10/100 Network
Connection (rev 02)
Subsystem: Dell Unknown device 0238
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin A routed to IRQ 10
Region 0: Memory at fdfc0000 (32-bit, non-prefetchable) [size=128K]
Region 1: Memory at fdfff000 (32-bit, non-prefetchable) [size=4K]
Region 2: I/O ports at fe00 [size=32]
Capabilities: [c8] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0
Enable-
Address: 0000000000000000 Data: 0000
Capabilities: [e0] Vendor Specific Information
00: 86 80 c0 10 07 00 10 00 02 00 00 02 00 00 00 00
10: 00 00 fc fd 00 f0 ff fd 01 fe 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 28 10 38 02
30: 00 00 00 00 c8 00 00 00 00 00 00 00 0a 01 00 00
The e100 driver doesn't recognise it and the "old" eepro100 also
doesn't. Would it be enought to add the PCI ID to one of these drivers
to get the card supported?
Erik
--
They're all fools. Don't worry. Darwin may be slow, but he'll
eventually get them. -- Matthew Lammers in alt.sysadmin.recovery
signature.asc
Description: Digital signature
