I'm writing a stream module that sits below the IP layer and does packet interception.
Can driver.conf be used for STREAMS modules to read the configuration parameters? Regards Ramakrishnan -----Original Message----- From: Rao Shoaib [mailto:[EMAIL PROTECTED] Sent: Friday, August 17, 2007 11:55 AM To: [EMAIL PROTECTED] Cc: [email protected] Subject: Re: [networking-discuss] File I/O from STREAMS module I am assuming that you want to read in some configuration parameters, if so, do a man on driver.conf(4) and on ddi_prop_get_int(9F). Rao. Ramakrishnan Meenakshi Sundaram wrote: > Hi all, > > I'm a newbie writing a STREAMS module, that will be part of the > network stack. It needs to read a configuration file to do its work. > > I'm not sure how to open and read a file from inside a STREAMS module. > > Since the online docs suggested uarea will be accessible from module's > open method, i tried file i/o from that method, it fails reporting Bad > Address > > I'm not sure how to use the M_COPYIN and M_COPYOUT, IOCTL messages to > read a file, as it is mentioned that these will be used to access the > user space. > > Kindly guide me. > > FYI : Sorry if you receive a couple of mails with same contents. After > i received an instruction saying this is a members only mailing list.I > subscribed to it. So, I'm forwarding this mail again. > > regards > Ramakrishnan > ---------------------------------------------------------------------- > -- > > _______________________________________________ > networking-discuss mailing list > [email protected] > _______________________________________________ networking-discuss mailing list [email protected]
