I have a DP server machine with two e1000 interface on the motherboard.
After installation of snv_83, snv_84 or snv_85, the e1000g1 will be OK, but
e1000g0 can not be used. Following is the output of 'ifconfig -a`:
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
e1000g1: flags=201000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4,CoS> mtu 1500
index 2
inet 10.0.1.3 netmask ffffff00 broadcast 10.0.1.255
ether 0:30:48:35:1d:41
lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252
index 1
inet6 ::1/128
I have tried to install e1000g0 manually, but failed. Following is the
output:
intel5# dladm show-dev
LINK STATE SPEED DUPLEX
e1000g0 unknown 0Mb half
e1000g1 up 1000Mb full
intel5# ifconfig e1000g0 plumb
ifconfig: cannot open link "e1000g0": No such device or address
I have installed builds from snv_77 to snv_82 on the same machine before and
this issue never happened. Does anyone have met this similar issue and how
to solve it?
--
zhihui
Intel OpenSolaris Team
_______________________________________________
networking-discuss mailing list
[email protected]
