shay writes:
> Thanks for your help...
>
> >You should at least see the same broadcast and multicast traffic on
> >all members of the group, if the network is wired up correctly.
>
> I can see those broadcast and multicast traffic, but I didn't see any other
> traffic!
OK.
> So How do I check that the ipmp work OK, in Active Active mode?
It sounds like you just did. There's nothing apparently wrong here.
However, if you're expecting load spreading to occur, then you're
going to need to have more than one IP data address assigned.
> There is a need for the "deprecated" key in order to built Active-active ipmp
> like-based?
No. "Deprecated" is a flag on the IP address assigned to the
interface. There's more information about it in the ifconfig(1M) man
page.
"Deprecated" is usually used with test addresses ("nofailover") for
probe-based detection.
--
James Carlson, Solaris Networking <[EMAIL PROTECTED]>
Sun Microsystems / 35 Network Drive 71.232W Vox +1 781 442 2084
MS UBUR02-212 / Burlington MA 01803-2757 42.496N Fax +1 781 442 1677
_______________________________________________
networking-discuss mailing list
[email protected]
