Dear All:
I have a data card, and it can support the usb ether feature.
But there are some problems to use in the linux systems:
1. While I plug the data card into the linux, and after the cdc_ether.ko
driver is attached to the device, the NetworkManager will be activated to add
our device in its list, and detach the IP of our device.
In this case, which signal or method_call will be received by the
NetworkManager from DBUS or HAL?
2. While I dial-up the data card to connect to the Ethernet, the
NetworkManager will not be activated to refresh the information, such as IP,
for our data card in the linux system.
I want to send some signal or method_call to NetworkManager by DBUS to
activate it in the user space.
Which signal or method_call can I send ? How to send them?
Hope for your help as soon as possible, thanks very much.
Best Regards,
Franko Fang
2009-3-17
******************************************************************************************
This email and its attachments contain confidential information from HUAWEI,
which is intended only for the person or entity whose address is listed above.
Any use of the information contained here in any way (including, but not
limited to, total or partial disclosure, reproduction, or dissemination) by
persons other than the intended recipient(s) is prohibited. If you receive this
email in error, please notify the sender by phone or email
immediately and delete it!
*****************************************************************************************
_______________________________________________
NetworkManager-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/networkmanager-list
