Hello,
How can I use network manager so that I can plug my girlfriends laptop into
port 1 of my computer, while port 0 is plugged to the loooong cable that
goes back to my encore 8 port switch and from there to my DSL modem?
I have tried to use bridge-control tools, and also acitvated packet
forwarding like this: echo "1" > /proc/sys/net/ipv4/ip_forward
I think the problem is around here:
me@pc:~$ ifconfig
eth1 Link encap:Ethernet HWaddr 04:4b:80:80:80:03
inet addr:192.168.1.4 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::64b:80ff:fe80:8003/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
eth0-eth1 Link encap:Ethernet HWaddr 04:4b:80:80:80:03
UP BROADCAST MULTICAST MTU:1500 Metric:1
See how the 2 ports have same MAC? How can I configure network manager to
handle 2 different ports? And how would I go about configuring it to route
packets out to the internet coming from my chicks's laptop?
Ubuntu 10.10
Asus Crosshair mobo version 1
Thanks,
_______________________________________________
networkmanager-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/networkmanager-list
