Hello,I have potentially found a small exception when adding a wifi connection
while device disconnected.
If I do:
dev_iface.Disconnect()...con_path =
nm_settings_iface.AddConnection(config)activate_connection(get_con_uuid_by_path(con_path))#activate
in case it was previously disconneced
but the config contains a faulty encryption key (psk)
I then monitor the progress with a
loopingdev_prop_iface.Get("org.freedesktop.NetworkManager.Device", "State")
it starts as expected with 50 for a while. Then it would normally give up and
switch to 60.I will then catch this and prompt for a new password.
BUT when we started with a disconnected wifi the state is switched back to 30
instead.Is this by design? I notice that there is no dev_iface.Connect()....
Complete code herehttps://github.com/vikjon0/qfpynm(I have kind of worked
around the problem but not sure if I will get sub seq issues)
best regards, Jonas
_______________________________________________
networkmanager-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/networkmanager-list
