Thnx. So lets say I previously created a bridge interface and linked in my
eth0:
$ nmcli connection show
$ nmcli connection delete <eth0|eth0-UUID>
$ nmcli connection add type bridge \
ifname br0 con-name br0
$ nmcli connection add type bridge-slave \
ifname eth0 con-name eth0 master br0
Presumably I create tap0 then add it to my br0 such as the following:
$ nmcli connection add type tun \
ifname tap0 con-name tap0 \
mode tap owner `id -u` ip4 0.0.0.0/24
$ nmcli connection add type bridge-slave \
ifname tap0 con-name tap0 master br0
Then I would be good to go with qemu and be all-set "automagically" at
every reboot as autoconnect=yes is set by default.
NM1.2 not yet available under Ubuntu 16.04 alpha (duno if planned to be
included?) so can't test it unless I recompile from source. Therefore in
the meantime it's more of a personnal knowledge thing than anything else.
Thnx in advance!
- vin
Le lun. 25 janv. 2016 à 03:22, Beniamino Galvani <[email protected]> a
écrit :
> On Mon, Jan 25, 2016 at 02:46:54AM +0000, Vincent Fortier wrote:
> > I was wondering how can I create a tap interface using nmcli? Search
> again
> > and again witouth luck...
>
> Hi,
>
> creation of tun/tap devices is supported only in NetworkManager 1.2.
> On such version you can create a tap connection using the command:
>
> $ nmcli connection add type tun ifname tap0 con-name mytap0 \
> mode tap owner `id -u` ip4 x.x.x.x/24
>
> The connection will have autoconnect=yes by default and so the device
> will be created automatically every time NM starts. You can manually
> enable or disable the connection with:
>
> $ nmcli connection up mytap0
> $ nmcli connection down mytap0
>
> Beniamino
>
_______________________________________________
networkmanager-list mailing list
[email protected]
https://mail.gnome.org/mailman/listinfo/networkmanager-list
