Hello, thanks for your answer.
I'm creating the connection on band wifi band a using this command: nmcli con add type wifi ifname wlan0 autoconnect yes ssid $(hostname) 802-11-wireless.mode ap 802-11-wireless.band a 802-11-wireless.channel 100 ipv4.addresses 192.168.201.1/24 ipv4.method shared wifi-sec.key-mgmt wpa-psk wifi-sec.psk TEST12345 I had a few problems to bring up the access point first, but when I changed the 802-1x.auth-timeout to 90 seconds (CAC time) and send the correct country code to wpa_supplicant over dbus the access point is coming up as it should. Everything is fine until I need to switch the channel because a radar event is detected by the driver. To simulate the radar event I use a debug feature of the WLink8 driver. I use the debugfs and write the channel to a specific file: echo 100 > /sys/kernel/debug/ieee80211/phy0/wlcore/wl18xx/radar_detection for triggering a radar event on channel 100. We used this in the past with hostapd and it worked really good. I'm not sure how I can tell wpa_supplicant to use wlan0 instead of p2p-dev-wlan0. I only create the nmcli connection and I think the network manager is then configuring wpa_supplicant over dbus. Thanks Nadja -----Ursprüngliche Nachricht----- Von: Beniamino Galvani <bgalv...@redhat.com> Gesendet: Montag, 10. Mai 2021 08:59 An: Stärk Nadja <nadja.sta...@wiedemann-group.com> Cc: networkmanager-list@gnome.org Betreff: Re: AccessPoint 5GHz DFS Channel Radar Detection Failure [ NICHT VERSCHLUESSELT ] [ SIGNATUR_UNPRUEFBAR ] On Wed, May 05, 2021 at 09:16:44AM +0000, Stärk Nadja wrote: > Hello, > > I'm working with NetworkManager v1.22.8 and face some issues with my 5 GHz > access point. > > I need to create it on DFS channel 100 and when a radar event is detected the > channel should be switched. > > Debug output of wpa_supplicant is enabled. > If I send a radar event through the debugfs to channel 100 now, I can see > that it was received by wpa_supplicant: > > nl80211: Event message available > > nl80211: Drv Event 94 (NL80211_CMD_RADAR_DETECT) received for > p2p-dev-wlan0 > > nl80211: DFS event on freq 5500 MHz, ht: 1, offset: 0, width: 1, cf1: > 5500MHz, cf2: 0MHz > > p2p-dev-wlan0: Event DFS_RADAR_DETECTED (42) received Hi, the event is detected on p2p-dev-wlan0, which is a P2P interface; probably it should be on wlan0 instead. How do you simulate the event? > But the channel is not switched. > > > I made some debugging in wpa_supplicant (v2.9) and figured out that the > function wpas_ap_event_dfs_radar_detected in ap.c instantly returned because > the wpa_s->ap_iface and the wpa_s->ifmsh is empty. > > > > Is the NetworkManager able to handle a fully working 5 GHz access point? Do I > just need to add some extra configurations? Yes, I think it should if you set property 'wifi.band' to 'a'. Beniamino _______________________________________________ networkmanager-list mailing list networkmanager-list@gnome.org https://mail.gnome.org/mailman/listinfo/networkmanager-list