I'm running MNF on a Pentium 100 with 56 megs of RAM. Slow, but it
works. Can you boot the failsafe kernel? You may need to pass a
parameter to the default kernel to get it to work with your particular
mb/chipset/processor/video/ram combination.
Sincerely,
Jim Hubbard
.--.
|o_o |
|:_/ |
// \ \
(| | )
/'\_ _/`\
\___)=(___/
Rockingham County Linux Users Group
www.rock.lug.net
____________________________________
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Lanman
> Sent: Thursday, December 26, 2002 10:02 AM
> To: [EMAIL PROTECTED]
> Subject: Re: [newbie] MNF INSTALL
>
>
> Don't quote me on this, but I think a K6/2-450 falls below
> the minimum
> architecture requirements for MNF.
>
> Lanman
>
> On Thu, 2002-12-26 at 09:49, Tom wrote:
> > I am trying to install MNF Mandrake on a AMD k6-2 450
> processor. The
> > cd booted and installation appeared to go smoothly until reboot.
> > The computer hangs at:
> >
> > Detected 451.834 MHZ Processor
> > Console: Colour VGA+ 80x25
> > Calibrating Delay loop...897.84 BogoMIPS
> >
> > This is a Epox Motherboard with AGP video Card.
> > I successfully installed MNF on another test machine with the same
> > motherboard but a amd k62 500 processor in it.
> >
> > Any suggestions?
> >
> > Thanks
>
>
>
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
