Hello all,
I installed a command line tool called "ethtool" I was curious about what
speed my nic was set at, its an onboard device SIS900 and I'm not sure where
the configuration file is at.
Anyways when I run the command "ethtool eth0" it says...
[root@avatar mike]# ethtool eth0
Settings for eth0:
No data available
but it shows me driver info...
[root@avatar mike]# ethtool -i eth0
driver: sis900
version: v1.08.02 11/30/2001
firmware-version:
bus-info: 00:03.0
I'm set up with my workstation connected to a hub which is connected to a
firewall/gateway box which is connected to a modem.
My hub I believe does 10mps, I picked up a used switch linskys 10/100mps
I have 10/100 nics in both boxs. I would like to see the difference it makes,
and learn about it. Like to be able to change and measure settings.
Questions= Where in MDK is eth0 settings at?
Has anyone used "ethtool" ?
or is there a better tool?
Mike
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
