I made the additional change you suggested to my lilo,conf file it now reads,
image=/boot/vmlinuz
label=linux
root=/dev/hda6
initrd=/boot/initrd.img
append="devfs=mount hdb=ide-scsi"
read-only
image=/boot/vmlinuz
label=failsafe
root=/dev/hda6
initrd=/boot/initrd.img
append="failsafe devfs=nomount hdb=ide-scsi"
read-only
But still no CDRW drive. When I rebooted just now, I got the same "FAILED special device /dev/scd1 does not exist" again. I checked /dev to see if there is a scd1 there and there is not. Nor is there an hdb.
I'm as certain as I can be that I have the jumpers set correctly. I did change the jumpers on the CDRW to slave when I installed it. Also I was able to access the CDRW drive and even "burn" a couple of CDs before logging off. yesterday. Now the drive doesn't appear on my hardware list. Perhaps a separate cable is the only answer??
|
LTR }}:{( ~~~~~~~ [EMAIL PROTECTED] http://www.bullovedbulldogs.com/ |
