On Mon, 05 Jul 2004 21:49:55 -0400, Ryan Steffes wrote > This is possibly a dumb question or at least a question with not > enough information, but I'm was trying to upgrade my kernel from the > 2.6.3-7mdk rpm to the source 2.6.7 from kernel.org (with the -ck4 > patch). The problem I'm having is that when I try to use it, it > seems to insist on using IPV6, so it's not getting any IP address > from my gateway. It ends up assigning some number to eth0 and then > some bad number to eth0:9 and basically not working. > > Any clues?
I had a similar problem moving from 2.6.3-7mdk to 2.6.3-14mdk (at least it appears similar). Eth0 would take forever to load (and eventually fail). Ifconfig looked like all the network interfaces were in IPV6 mode. My solution was to check the 'no acpi' box in the mcc boot config. Never spent any time looking into it beyond that, but I did notice that ifconfig reports IPV6 information even on a non IPV6 network. I suspect the nic hardware was just not being setup properly, and lacking a solid IPV4 ip address, ifconfig reported only the IPV6 info. Scott -- Nothing goes to waste when Little Fish are near! (http://www.littlefish.ca)
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
