Thanks for this, it now works perfectly !!! Cheers,
Jamie -----Original Message----- From: news [mailto:[EMAIL PROTECTED] On Behalf Of Bj�rn Lundin Sent: 09 September 2004 18:10 To: [EMAIL PROTECTED] Subject: [newbie] RE: Re: Sending AT commands programmatically Jamie Kerwick wrote: > Thanks this works a treat !! Much appreciated. > > Now if only I could get a regular user to be able to access the com > port > ;) > > chmod the tty or, preferably, make that user a member of the tty group /Bj�rn ************** E-mail Disclaimer ************** This e-mail message is confidential and for use by the addressee only. If you are not the intended addressee, please reply to the sender and then delete the message from your computer. Please note that any views or opinions presented in this e-mail are those of the author and do not necessarily represent the views or opinions of The Benenden Healthcare Society Limited. You should check this e-mail and any attachments for the presence of viruses. The Benenden Healthcare Society Limited accepts no liability for any damages caused by any virus transmitted my this e-mail or its attachments. The Benenden Healthcare Society Limited is an incorporated friendly society, registered under the Friendly Societies Act 1992, registered number 480F. The Society�s contractual business (the provision of tuberculosis benefit) is authorised by the FSA. The remainder of The Society�s business is undertaken on a discretionary basis. The Society is subject to FSA requirement for prudential management. Registered Office Address: The Benenden Healthcare Society Limited, Holgate Park Drive, York. YO26 4GG. Tel: 0870 7545 700 Fax: 0870 7545 822 www.benenden.org.uk
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
