On Monday 25 October 2004 12:38, Alexander Ruoff wrote: >But I have a config tool for wireless. When I set up a new network >connection, I have wireless as an option but even though I tried to set >it up that way I always end at the option "manual" or "automatic" setup, >no matter which option I choose. > >The problem with ifconfig in the command line is that it doesn't show >eth1. I only get eth1 when I type ifconfig eth1...
This sounds like you didn't install the firmware properly. For 10.1 you need the firmware version 0.54. Once that was installed in the right place, I could go past the point of choosing between "manual" or "automatic" and properly set up the device. However with the version 0.54 (wich is the one included in 10.1 Community) i could not get encyption to work, I had to upgrade to 0.55. sebastian
____________________________________________________ Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com Join the Club : http://www.mandrakeclub.com ____________________________________________________
