Dacia....well since you ask. I normally wouldn't comment on
this problem because I don't have that soundcard and have
never experienced that error message.
I would suspect a IRQ conflict (or possibly an I/O port or DMA
channel conflict). I would remove all other cards and see if
the soundcard would install (hopefullly automatically by
kudzu) then. If so then I'd add the other cards back one at a
time and let kudzu find them and install them. By recording
the IRQ, IOport address and DMA used as each is installed you
can se when the conflict first occurs.
Alan
Dacia and AzureRose wrote:
>
> SBLive works fine in 7.02. In fact, I am convinced
> that the sound quality with this card is superior in
> linux.
>
> I am afraid, however, that your problem is WAYYYY over
> my head though. Alan? DO you have any insight to
> offer here? Anyone else?
>
> Have you searched the knowledge base at:
>
> http://www.mail-archive.com/[email protected]/
>
> for details related this problem?
>
> Good Luck!
>
> Dacia
> --- RJS II <[EMAIL PROTECTED]> wrote:
> > Hi,
> >
> > Try getting 7.1. I have one and it works great.
> >
> > Hope it helps,
> > Rob Saul
> >
> > On Mon, 17 Jul 2000, Adriaan Barel wrote:
> > > Hi,
> > >
> > > I've just installed an SB Live! Value PCI sound
> > card and I cant get it
> > > to work at all in MDK7.0 . I have tried running
> > sndconfig which
> > > detects the card OK but when it says it will
> > perform a sample sound I
> > > get the following error message:
> > >
> > > The following error occured running the
> > > modprobe program:
> > > /lib/modules/2.2.14-15mdk/misc/emu10k1
> > > o:init_module: Device or resource busy.
> > >
> > > I have downloaded, compiled and installed the
> > lastest emu10k1 driver
> > > from www.opensource.creativelabs.com but I still
> > get the same error
> > > message.
> > >
> > > I have tried commenting out all sound related
> > lines in the
> > > /etc/conf.modules and then did
> > > depmod -a (which completes ok) then i do
> > > modprobe emu10k1 (AND I GET THE SAME ERROR
> > AGAIN)
> > >
> > > I have also tried configuring it through DrakConf
> > - Hardware
> > > configurations. And surprise, surprise, I get the
> > same error again!
> > >
> > > I must say it is very frustrating considering that
> > I replaced my old
> > > card with the SB Live! specifically for sound in
> > Linux and now it wont
> > > work. The reason why I bought the SB card, was
> > because it was supposed
> > > to be very compatible.
> > >
> > > If anyone could enlighten me regarding this
> > problem I would be very
> > > grateful.
> > >
> > > Regards.
> > > Adriaan
> >
>
> __________________________________________________
> Do You Yahoo!?
> Get Yahoo! Mail - Free email you can access from anywhere!
> http://mail.yahoo.com/
