Dennise,
After LM7.0 was installed I switched my drive up to ATA/66 mode and it
worked just fine with Mandrake. I understand that there may be problems when
installing and using /66 mode, and with Promise controller cards (which
require a patch if I recall what I read in newbie correctly). -Gary-
In a message dated 10/19/2000 11:06:56 PM Eastern Daylight Time,
[EMAIL PROTECTED] writes:
<< "Kelly, Christopher" wrote:
>
> I have one IDE drive hooked up to an Ultra ATA/66.
> Even if I select "no" at the prompt, it brings it back up...(sigh)
>
Does LM 7.1 fully support ATA66? I seem to remember something about 7.2
would but can't recall where or when, I'm getting old and crotchetty.
Somebody know about ATA66?
--
Dennis M. a registered Linux User #180842
>>
- Re: [newbie] Install problems Dennis Myers
- Re: [newbie] Install problems Rod Baxter
- Re: [newbie] Install problems Mark Weaver
- Re: [newbie] Install problems Mark Weaver
- RE: [newbie] Install problems Kelly, Christopher
- Re: [newbie] Install problems Tom Brinkman
- RE: [newbie] Install problems Dodd Carlton J MSgt 726 ACS/CSG
- RE: [newbie] Install problems Kelly, Christopher
- RE: [newbie] Install problems GAPrichard
- RE: [newbie] Install problems Kelly, Christopher
- [newbie] Install problems Joe Finnie
- [newbie] Install problems Curt Tresenriter
- Re: [newbie] Install problems C. Tresenriter
- Re: [newbie] Install problems Tom Brinkman
- Re: [newbie] Install problems Andy Davidson
- Re: [newbie] Install prob... Stephen Kuhn
- Re: [newbie] Install prob... Ian Trickett
- Re: [newbie] Install problems, OT... FemmeFatale
- Re: [newbie] Install problems... Erylon Hines
