Hmmm.......
Are you *really* supposed to be using a static IP address?
--Greg
----- Original Message -----
From: "William Presho" <[EMAIL PROTECTED]>
> Hi Greg
> Well I set up like you said but still no luck.
> Bill
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Greg Stewart
> Sent: Sunday, October 22, 2000 3:50 PM
> To: [EMAIL PROTECTED]
> Subject: Re: [newbie] Unable to get Cable Modem Working
>
>
> Alright, I just re-installed my MDK7.1 partition, so I can look at what
> you're talking about.
>
> I'll be using your information to compare against what I have, and what
has
> worked for me:
>
> > > under Host name tab input the DNS Name provided to me by @Home
>
> Null this out, and enter only the machine host name (no
dot-domain-dot-com).
>
> > > Under Adaptor 1 tab
> > > Primary Name + Domain: my user name + subdomain address as provided by
> @Home
>
> Same as previous.
>
> > > I/O port 0 x 1000
> > > IRQ = 9
>
> Null both of these, leave blank.
>
> > > Next went to Routing and gateways, clicked on Set and entered my
Gateway
> IP
>
> Return this to the Defaults
>
> I have found when I "over-configure" the out-bound NIC, things don't work
> properly. This could be the case with your configuration...it's worth a
> shot.
>
> --Greg
>
> ----- Original Message -----
> From: "Anthony F. Littrel Sr." <[EMAIL PROTECTED]>
> > William Presho wrote:
> >
> > > The steps I took to configure the card are as follows:
> > > Started DrakConf
> > > Clicked on Network Configuration
> > > Under Client Tasks tab, clicked on Basic host information
> > > under Host name tab input the DNS Name provided to me by @Home
> > > Under Adaptor 1 tab I set it up as follows
> > > Config mode: Manual
> > > Primary Name + Domain: my user name + subdomain address as provided by
> @Home
> > > No Aliases
> > > Next input the IP address
> > > Put IN Netmast, net device eht0
> > > Kernel Module rtl8139
> > > I/O port 0 x 1000
> > > IRQ = 9
> > > Next put in IP of Name Server (DNS) 1 and 2
> > > Next went to Routing and gateways, clicked on Set and entered my
Gateway
> IP
> > > Then Quit Quit and Activate Changes
> > >
> > > As I stated before this setup will let me connect to the cable modem
and
> use
> > > the internet. But if I shut the computer down and then restart it I
get
> the
> > > following:
> > > Delay eth0 initialization Failed
> > > Starting httpd: httpd:cannot determine local host name
> > > Use the ServerNameDirective to set it manually Failed
> > >
> > > I hope this will help you to figure out what is wrong and how to fix
it.
> > > Thanks Bill
> > >
>
>
>
>
____________________________________________________________________________
> __
> Vous avez un site perso ?
> 2 millions de francs � gagner sur i(france) !
> Webmasters : ZE CONCOURS ! http://www.ifrance.com/_reloc/concours.emailif
>
>
>
>
______________________________________________________________________________
Vous avez un site perso ?
2 millions de francs � gagner sur i(france) !
Webmasters : ZE CONCOURS ! http://www.ifrance.com/_reloc/concours.emailif
