I wouldn't put in any I/O settings or IRQ unless it didn't work without them. > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of john > Sent: Friday, November 10, 2000 1:17 AM > To: [EMAIL PROTECTED] > Subject: [newbie] 3Com: irq parameters not found.... > > > Hi, > > I am trying to get my 3com 3c90x config'd. I have > entered all the data correctly per my isp; ip, mask, > dns, host, domain etc.... > (running a small network dsl->router->hub->box) > > I checked the irq on windows, it gave 10 (dual boot). > So i tried irq=10,eth0 on Mandrake, no luck. > I get the following message during load up. > "symbol for parameter irq not found......ethx not > initialized". > > I have tried most combinations with ethx and irq. > I assume its not set correctly to the proper irq > and/or I am using the wrong ethx. > To run a control, I changed the irq 1-11 with both > eth1 and eth0 just be sure. > > I get the same error, regardless.? > > The hardware scan recognizes the card, and shows the > right driver for it as well. > As well, I know the card works. > > Any ideas.......? > I am sure this is operator error. ) > Thanks for your time, > > john > > > > ===== > > > __________________________________________________ > Do You Yahoo!? > Thousands of Stores. Millions of Products. All in one Place. > http://shopping.yahoo.com/ >
