On Friday 10 November 2000 10:41 am, -michael- wrote:
> and how can I attach a fan to my voodoo3 2000 when it has those
> spiked heat-sink dealiebobs on it?
I use a sheet metal screw into the space between the fins. Just
one screw in one corner. Mine's been on there for over 1 1/2 years,
'cept to take it off to clean the heatsink. I also have a V3-2000.
It has a thermistor and you can monitor the temp using lm_sensors or
Khealthcare if your motherboard supports it. They run hot, mine
runs a steady 48C with a 4500rpm fan on it. In Windoze it's
overclocked to 178mhz, then it runs close to 60C. I've found it's
better to have the fan sucking air off, rather than blowing onto the
hs. YMMV, depending on your case ventilation.
--
Tom Brinkman [EMAIL PROTECTED] Galveston Bay
