I have a Toshiba Tecra 8100, and the graphics chipset on it is a S3
Savage. I had to find beta drivers for it. Find out who makes your card,
and look to see if you can find a linux driver for it. If you find one,
and can figure out how to install it, write back.
Steve Combs wrote:
>
> I just installed Mandrake 7.2 on a Toshiba Satellite Pro 430CDT. I can't see the
>entire screen. The cursor will move off the screen on the bottom and to the right
>about 2 inches further than I can see. It doesn't appear to be related to the other
>virtual desktops. When I try to change the resolution under Xdrakres I only get a
>please wait box that shows up for a split second. I have reinstalled three times
>choosing first 1024x768 and then 800x600 under generic LCD then going with 1024x768
>generic SVGA display. According to the spec sheet this laptop is capable of 1024x768.
>The chipset is Chips and Technologies CT65550. When output is sent to a 17" monitor
>the entire display shows. When output is sent to both the monitor and laptop the
>display is cut off on both. Any ideas or suggestions would be appreciated. Worst case
>I'll just use the external monitor. Thanks in advance.
--
|-------------------------------|
Peter Marks
E-Mail:[EMAIL PROTECTED]
ICQ:46202991
http;//www.tweeterindustries.net
|-------------------------------|
