Hardware:
AT Motherboard / 80MB ./ Cyrix 8x96 chip @ 233Mhz
D-Link DFE-530 TX+
Brand new installation went great except for graphics, which tested fine,
but on the reboot the screen was black. Booted as single and fixed that.
Now, how do I configure the DFE 530 TX+ for eth0? I've tried using
DrakConf/"Network and Internet Configuration". I picked the Via Rhine,
which this card uses. It says that it found one, and then goes away.
Actually it says it finds whatever NIC entry I click on for that matter.
I would like to get this up and running as eth0 using DHCP. Any ideas
welcome!
Thanks,
-rick
winmail.dat
