Forever never goes beyond tomorrow. > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of P_dog > Sent: Thursday, February 08, 2001 1:45 PM > To: [EMAIL PROTECTED] > Subject: Re: [newbie] VIA KT133A ANd duron support > > > I have the KT133A chipset and a Anthlon 800 duron and I just > did a regular > install and all three hdd's where detected just fine. No > additional steps > where needed here. > > Amd Anthlon 800 (duron, which has thunderbird stepping) > > Tyan kt400 MB (kt133 chipset) > 384 meg ram > two WD hdd 45 gig ata/100 7200rpm > one WD hdd 18 gig ata/66 5400rpm > > works just fine unless im too stupid to know its not working :) > > Tyan only has 1 socket A MOBO The Trinity KT (S2390) and unless you have added an ATA100 controler card your 2 WDs are running at PIO 4 not 5 this is why you ran into no problem during the Mandrake installation. Point of fact. The 7.2 installation will not recognize any onboard ATA100 controllers unless you pass the parms to the kernel and even then it may still hang during partition check. Charles (-: Forever never goes beyond tomorrow.
