I ordered a LM8.0,however to my dismay,I could not proceed form one step
of installation.The boot CD will boot ,after loading the Ram disk and it
gives error and aborts the installation.I confirmed that it was a CD
problem.However LM support choose to ignore all my e-mails and
fax asking for a replacement CD....not even a reply in spite of quoting
my registration ID.Then i spent three full days trying to down load
cd1...and finally suceeded.
My next problem is that ,the software cannot mount the SCSI cd
drive.The SCSI card i have is BUSlogic BT-946C.The CD boots from the
drive,BUs logic card is detected then it gives me an error saying "no
Cdrom device found".I tried to boot from a boot
disk made with windoz and booted from it.Here also the SCSI card was
detected,then i get an error saying"I could not mount a CD on device
/dev/scd0".The CDrom i have is plexter PX-8XCS.However LM7.2 loads and
runs verywell in this same setup.
I need some help on this.
-
Ivan Miranda
General Instrument Engineer/IT support
Po Box 8746,Doha,Qatar
Ph:974-4402524/4402773
Fax:974-4323380
