I am not sure but try this
in console type
cat /proc/pci
you will get a long list. Look for a line that says
Communication controller. Look a little below that
you will see something like:
I/O at 0xa800
I/O at 0xa820
I/O at 0xa840
Find the IRQ number. It should be above the I/O line.
Then at the console type
setserial /dev/modem uart 16550AN port 0xa800 irq 11
note that I put 16550AN mine was 16550A try both. I
also put 0xa800 for port but yours might be different.
My modem was at IRQ 11 and yours might be different
--- Lee Hoffner <[EMAIL PROTECTED]> wrote:
> All:
>
> I'm up now. I yanked my #2 video card and re-did the
> install. Everything worked fine. (Even got a graphic
> install instead of text this time!)
>
> Remaining on the to-do list:
> Get that 2nd vid card back in
> Find out why modem doesn't respond. (I'm writing
> this in Windows)
> Get scanner to work
>
>
> Modem is number one on my list. Can anyone advise
> me?
>
> device properties in Win:
> US Robotics 56k voice Int PnP
> Com3
> IRQ: 5
> Address: 3E8
> UART: NS 16550AN
>
> In Mandrake Control Center, I can't find a way to
> stipulate com3; there is no field for address
> (although there is I/O, but no choice matches my
> address info); UART is not an available setting.
>
> Thanks for any and all help!
> --LH
>
>
=====
Regards,
OOzy
What is the purpose of life?
__________________________________________________
Do You Yahoo!?
Spot the hottest trends in music, movies, and more.
http://buzz.yahoo.com/
