Well, is it USB or parallel (external and plugging into the computer) or mounted within and attached to a SCSI Card? Or is it IDE? IDE is attached by a 40 pin cable to a plug on the motherboard SCSI is attached by a 50 pin cable (or 68 pin cable or 80 pin cable with adaptors) Parallel attaches with 25 pin d-subminiature connector usually on the back of ths computing box USB uses little flat connectors and what looks a lot like telephone wire between them. Unless we know how your ZIP is connected, it is unlikely that we can be of any help. A SCSI zip might be a problem if you are using an Adaptec card. Right before release of 8.0, there was a new driver issued to accommodate firmware changes. The firmware is not flashable on all adaptec cards, so the old driver is needed for some. If you have that problem put this in the next to last lines of /etc/rc.local rmmod aic7xxx modprobe aic7xxx_old You can tell if you have an Adaptec (and tell us) by lspci -vvv > transfile then attaching transfile to your email here. If you page through it, you will see the devices in use on your motherboard and on the attached cards. Civileme
Want to buy your Pack or Services from MandrakeSoft? Go to http://wwww.mandrakestore.com
