At 23:08 14/08/01 -0400, you wrote:

>Before you go as far as MOUNTING a remote share or utilizing a remote
>printer under Samba you should test to make sure that your Linux machine
>is able to LOG IN to the winblows machine...
>
>Try
>
>"smbclient -L machine -U user"
>
>Where "machine" is the name of the Winblows machine and "user" name you
>are CURRENTLY using on your Winblows machine to log into the network...
>
>You should see something like this
>
># smbclient -L whopper -U admin
>added interface ip=10.0.0.1 bcast=10.0.0.255 nmask=255.255.255.0
>
>Password:
>
>
>
>         Sharename      Type      Comment
>
>         ---------      ----      -------
>
>         CDROM          Disk
>
>         E              Disk
>
>         D              Disk
>
>         C              Disk
>
>         IPC$           IPC       Remote Inter Process Communication
>
>
>
>         Server               Comment
>
>         ---------            -------
>
>
>
>         Workgroup            Master
>
>         ---------            -------
>
>#
>
>Notice that it prompted for a WINDOWS password, then displayed the
>shares...
>
>If this does not work for you, you either have SAMBA configured
>incorrectly (did you set up your Linux box to act as a SAMBA server yet?
>The samba client uses the settings from the /etc/smb.conf or
>/etc/samba/smb.conf files for the server!) or the username and password
>pairs you are giving are not recognized by Winblows.
>
>Once you have something similar to the above displaying, use the
>accepted login to set up your remote Winblows printing.
>
>One step at a time makes things easier to debug.
>
>-JMS

At first I couldn't connect to the windows machine using samba. I would get 
a connection failed error. After I re-installed LM 8.0 from scratch (since 
I have some time on my hands I can afford to do this) the first thing I 
tested was smbclient and I successfully connected to the windows machine.

So I setup the printer and sent a test page to it. It would start printing 
fine but would stop for no reason at the beginning of the page. I tried 
setting the printer up both through Mandrake Control Center and Cups. At 
least I'm moving forward!

Guilherme Cirne
[EMAIL PROTECTED]


Want to buy your Pack or Services from MandrakeSoft? 
Go to http://wwww.mandrakestore.com

Reply via email to