I am installing PowerChute Plus, from APC, for my Back-UPS. When I run the Configuration Tool, I am getting these messages:
Checking for binary compatibility... binary compatibility VERIFIED /dev/ttyS0 verified as a valid tty The following Port validations for /dev/ttyS0 may take a few moments.... /dev/ttyS0 appears to be a local control port ---------------------------------------------------------------------------- WARNING: Port must be configured for modem control in order to work with a "Simple" Signaling UPS ---------------------------------------------------------------------------- Press Enter to continue ---------------------------------------------------------------------------- WARNING: Could not communicate with device on /dev/ttyS0. Check that the communications cable is attached properly to both the device and the serial port. ---------------------------------------------------------------------------- NOTE: Though the PowerChute Plus for UNIX installation is complete, if you quit before verifying communications, the application may not work properly ---------------------------------------------------------------------------- The Back-UPS is reciveing a signal from the computer because the light is flashing. I do not understand what the modem control is. If you can help me, that would be great. Bob Bomar
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
