Title: SNF start up
|
----- Original Message -----
Sent: Thursday, May 16, 2002 2:49
PM
Subject: [newbie] SNF start up
Hi all, wondering if anyone has used Single Network
Firewall? I have installed it on a K6-II 266mhz computer, an old gateway
desktop case and 400mb harddrive. the install went fine but now I don't have a
clue as to how it starts. When you boot it up with a monitor still connected
it boots to the login prompt. I assume it is not started. The nearly 300 page
manual does not indicate that you have to start it and then unplug monitor and
keyboard or if you somehow start it when you access via the https://192.xxx.xxx.xxx:port# So I need a little help
just getting into it to configure my cable modem setup. Thanks for any help or
suggestions.
Dennis M.
You must log in using the admin account that was created
during the setup and it'll prompt you to make changes to your Internet
connection and internal LAN setup then you can do the rest of the
configuration via a web browser using HTTPS://192.xxx.xxx.xxx:port# once this is all done you will be able;e to have it route
your internet connection via IP MASQ. I tried SNF and I didn't find it did
what I was looking for so I tried a few others and I found that the a-smith
gateway worked best for me (www.esmith.com) but I had some very strange
requirements.
Socratez
|
