On Wed, Dec 12, 2001 at 10:12:16AM -0700, Charles Vavra wrote: > Hi, I have an IWILL 266 board with an 1.33 htz chip installed and have > installed SuSe 7.3 on the drive. SuSe is the only running system and I'm > trying to configure my graphics card, its a Nvidia GeForce 2 MX 400. I > upgraded to 4.1.0 and still can not seen to get the 3D graphics to work. > It comes to my attention that the monitor I'm using is from my Macintosh > setup before I switched over to Linux. Its a Sony 300 sf and the > different resolutions listed in the operating booklet that came with it > show both resolutions for VESA and VGA. Will this monitor work ?
monitor has nothing to do with graphics performance or capability; only with display capabilities. X only cares about where to start and end the monitor signals, and how fast to send them; drawing the actual image in the graphics card's framebuffer is another matter entirely. so the answer is yes, your monitor will work. (to some extent or another). Carl Soderstrom -- Network Engineer Real-Time Enterprises www.real-time.com _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
