Hi, sorry if this message arrives twice, I don't think it went through the first time. Anyway. I have a fresh install of Debian Potato 2.2.19pre17 from ISO Disc 1. I installed it with an XFree86 3.x core install, and then downloaded the 4.2.0 binaries for GLIBC 2.2. I installed the binaries with Xinstall.sh, but when I ran xinit, I got an error about the GLIBC version. So, I installed libc6 v2.5, and it ran (sort of). It complained that there were "no screens found". So I ran XF86Config (the 4.x version came up), and made a config file which should have been appropriate (I used the settings that worked from my 3.x config.) But now, when I run xinit, I get the following error:
"Fatal server error: Caught signal 11. Server aborting" When I install Debian with NO xf86 at all, and run the Xinstall.sh, when I type "xinit", it just says "command not found", like it wasn't installed, even though, the new XF86Config is now available when I do that. When I compile v4.2.0 from source, nothing seems to happen at all after it compiles and installs. If I have XF86 v3.x installed, it stays that way. If no X is installed, nothing shows up at all, xinit still doens't work. I read that removing glide_drv.o would help, but that isn't even in my system at all, so that didn't help. My system is as follows: Kernel v2.2.19pre17 Debian Potato 2.2 Distro 3Dfx VooDoo 3 2000 PCI Video Card AMD Duron CPU 256 MB RAM Any advice would be appreciated. Thanks :) -- Get your free email from www.linuxmail.org Powered by Outblaze _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
