Choose a driver that matches your video chipset, if your card is not listed. Check the driver list at xfree86.org to make sure that your chipset is supported under 4.2.0.
Vic Roberts -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Desmond Lee Sent: Tuesday, June 25, 2002 11:28 AM To: [EMAIL PROTECTED] Subject: [Newbie]support for matrox millennium g450 Hi there I just installed free bsd and i'm trying to get xfree up and going. I had xfree 3.3.6 installed, however that didn't support my matrox g450 card. Xfree release 4.2.0 says that it now supports g450 but when i install xfree 4.2.0 and then run # xf86config they do not show the matrox g450 video card as an option when specifying your video card. The closest thing is g400. I tried doing this, and the x windows doesn't work properly. When i run # startx I get a partial interface where you can't use the mouse and the resolution is really low and you only see 1/4 of the gui (the upper left hand corner). Does anyone have any ideas? thanks desmond _________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
