Go here: http://www.matrox.com/mga/support/drivers/files/lnx_200.cfm
1. download the g400 drivers & the powerdesk utility
2. read the release notes
3. install the drivers
4. restart the X server
5. install powerdesk
6. run mgapdesk
7. choose the dual-head multi-display option
8. adjust your displays (refresh rate, resolutions, ...)
9. save & exit
10. enjoy
The dual-head setup works perfectly except that 3D hardware acceleration
(DRI) is only supported in single-head mode :(
I attached my XF86Config files just in case...
Hope it helps.
__
Jorge
-----Original Message-----
From: Emanuel Haupt
To: [EMAIL PROTECTED]
Sent: 7/3/02 1:44 PM
Subject: [Newbie]dual screen
hi,
i have a matrox MGA G400 AGP card with two monitor outputs. how can i
make xfree86 to switch with the mouse from screen1 to screen2? someone
have me the hint to use xf86cfg but that did not really help. i think
it would if i had two completely different graphic cards.
Section "Device"
Identifier "Card0"
Driver "mga"
VendorName "Matrox"
BoardName "MGA G400 AGP"
BusID "PCI:1:0:0"
EndSection
has maybe someone the same card and made experiences with it?
emanuel
_______________________________________________
Newbie mailing list
[EMAIL PROTECTED]
*** To unsubscribe , or change message options, see:
http://XFree86.Org/mailman/listinfo/newbie
XF86Config-4.dri
Description: Binary data
XF86Config-4.dualhead
Description: Binary data
