----- Original Message ----- From: "David Fawcett" <[email protected]> To: <[email protected]> Sent: Friday, December 04, 2009 3:06 PM Subject: [OSM-newbies] Coastline issues?
> > I have been cleaning up the harbor coastline near Duluth, MN, USA. > http://www.openstreetmap.org/?lat=46.75019&lon=-92.06778&zoom=15 > > When I look at the Osmarender layer to see how my edits were rendered, > the water is not symbolized. My guess is that I did something to > screw up the topology of the coastline. > > One suspect edit is where the coastline followed a high bridge across > the harbor. I removed the segment of way that incorrectly connected > the two sides of the harbor and tried to connect the ways denoting > each side of the bay underneath the bridge on their respective sides. > > Can anyone take a look at this and confirm that this is the case (or > suggest what the problem could be? > David One coastline way was triplicated. and in one way there was a small gap between the end of the way and the start of the next section of coastline. I've fixed these issues http://www.openstreetmap.org/browse/changeset/3289175 nad asked for the osmarender layer to be re-rendered , so we'll see how it looks a bit later. David > I hate to revert back because I did a lot of detailed tracing. I > would much rather just fix the issue. > > Thanks, > > David. > > _______________________________________________ > newbies mailing list > [email protected] > http://lists.openstreetmap.org/listinfo/newbies > > _______________________________________________ newbies mailing list [email protected] http://lists.openstreetmap.org/listinfo/newbies
