Hi all.finally i find the answer.
1- we had Catalyst 6500 series with MSFC2/PFC2 and the netflow export config
differ from software-base router.if you want the SRC/DST interfaces records on
exported netflow packets , run these command on global configuration mode :
Router-Odd(config)#mls nde interface
Router-Odd(config)#mls flow ip interface-full
this cause the switch add interface number to exported netflow data.but note
the interface addresses are not the traditional interfaces naming on cisco
devices (like serial 0/0 , fastehtethernet 3/1 or Vlan18) , else it use the
SNMP ifindex schema for exported flow.
to see the snmp ifindex with corresponded traditional interface numbering ,
run this command on privileges exec mode
Router-Odd#show snmp mib ifmib ifindex
GigabitEthernet9/4: Ifindex = 104
GigabitEthernet9/5: Ifindex = 105
GigabitEthernet9/6: Ifindex = 106
.
.
.
Best Regards
---------------------------------
Looking for a deal? Find great prices on flights and hotels with Yahoo!
FareChase.-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Nfdump-discuss mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/nfdump-discuss
