Yes, and you change your oil every 3,000 miles also, don't you? Besides which, it's a Toyota, and I have seen the insides of neglected Toyota engines with little or no wear at over 100,000 miles. I have also seen Detroit iron with 60,000 to 80,000 miles which needed to be bored out to accept .030 oversized pistons. I will never forget the dismay I felt when I looked inside of that first Toyota engine and saw the cylinder walls with the honing marks still showing. I said to my buddy, they put us to shame... Then, the alloy Porsche used in its valves for the 911 didn't need to be adjusted but every 15,000 miles. That's a lot - for an air cooled engine without self-adjusting lifters, especially considering the clearance was something like .002 in. It's like sticking a flat wet noodle in this space between the rocker and the valve stem that - well, you can't see most of them, anyway. I would not put a gauze filter in my car, esp. if I am going to go 25,000 miles between oil changes. That's too much of a load for any oil filter.
Stanley ----- Original Message ---- From: Kyle Munz <[EMAIL PROTECTED]> To: [email protected] Sent: Monday, October 6, 2008 1:26:52 PM Subject: [Nighthawk Lovers] Re: Gas in air filter Yeah, I still say there's no danger in gauze (K&N) filters aslong as you clean and oil them properly. 200K+ miles on my tacoma, which has been breathing behind a K&N the whole time, and the cylinder walls and intake valves still looked new. -Kyle On Mon, Oct 6, 2008 at 1:45 PM, stanley/ Randolph <[EMAIL PROTECTED]> wrote: Well, there is this huge markup I have heard about at the "stealerships"; but $80!?!? A reusable foam, which improves airflow nearly as well as gauze but without the intrusion of dirt which is inherent in gauze filters, is not that much. And it is good for probably more miles than you will log on your bike for as long as you own it (100,000). Stanley ----- Original Message ---- From: Susan Sande <[EMAIL PROTECTED]> To: [email protected] Sent: Monday, October 6, 2008 11:32:19 AM Subject: [Nighthawk Lovers] Re: Gas in air filter $80??? I paid about $16 for mine. On Mon, Oct 6, 2008 at 9:57 AM, Angela <[EMAIL PROTECTED]> wrote: ok thanks, Stan!! so I don't have buy a new one? I see they cost almost 80 bucks, yikes!! ----- Original Message ---- From: stanley/ Randolph <[EMAIL PROTECTED]> To: [email protected] Sent: Monday, October 6, 2008 12:24:53 PM Subject: [Nighthawk Lovers] Re: Gas in air filter Regardless of the filter medium - usu. paper - it will dry out and should be be fine; and yes, it should remain dry. If it gets wet, air cannot flow as well through it and you will use more fuel because it is sort of like having the choke on. Stanley ----- Original Message ---- From: Angela <[EMAIL PROTECTED]> To: [email protected] Sent: Sunday, October 5, 2008 8:17:44 PM Subject: [Nighthawk Lovers] Gas in air filter I overfilled my gas tank and gasoline overflowed into the air filter. Should I replace my air filter or can I let it dry out? It should always remain dry, right? --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
